I have a pre-lit xmas tree (actually two) where sections of the tree are not lit up. I bought replacement bulb sand went through and tested each dark bulb in one area till I found the bad bulb, then replaced it with a new one and that section worked. I have however one other section wher there are actually two bulbs missing including the little base that the bulb actually sits in and then is pushed into receptical that's attached to the tree. I cannot for the life of me find any replacement bases, and I can't find the spares that came with the trees. Anyone have any ideas where I could find replacement bases. Second anyone have any better suggestions for figuring out which bulb is dead?
All content owned by CycloneFanatic.com - All rights reserved 2005-09. By viewing this website you agree to the Terms of Service, Site Rules and Legal Disclaimer. The words, views, images and opinions expressed or provided by users do not reflect the opinions or views of CycloneFanatic.com or Iowa State University. The names, words, symbols, and graphics representing Iowa State University are trademarks and copyrights of the University protected by the trademark and copyright laws of the United States of America and other countries and are used on this web site under license from the University. Original site design, premise & construction by Jeremy Lind.