I just had a new circuit board put into a single door Genie opener. Apparently this model had some weiny circuit boards for several years and mine was mash. Had him lube the doors while he was doing that. Guess name brand is not everything.
I would call your garage door opener person and ask him what it might be.
CFH HMagic bball season.
Let my fred's Four Horsemen ride.
If the door came up all the way but the garage door opener kept running then I would say the limit switch that stops the motor when the garage is fully opened went bad and either stripped out a plastic gear or busted a shear pin depending on the age of the garage door opener. Might be fixable or might be cheaper to replace.
Well, the gear is definitely stripped. Now I'm worried that the limit switch is bad. I'll probably start with the gear, and see if it stops before hooking up the door.
Same thing happened to mine a couple years ago. I looked it over and decided it wasn't worth taking it all apart to replace the gear and then start trying to figure out what caused the thing to keep running. I was able to buy the same model opener and just replaced the head(motor). Good luck.
All content owned by CycloneFanatic.com - All rights reserved 2005-09. By viewing this website you agree to the Terms of Service, Site Rules and Legal Disclaimer. The words, views, images and opinions expressed or provided by users do not reflect the opinions or views of CycloneFanatic.com or Iowa State University. The names, words, symbols, and graphics representing Iowa State University are trademarks and copyrights of the University protected by the trademark and copyright laws of the United States of America and other countries and are used on this web site under license from the University. Original site design, premise & construction by Jeremy Lind.